I've used Xpadder before, and I able to get it to repeat button presses indefinitely while I held a button on my control.
I can't figure out how to do it anymore
When I held the right trigger, it would press 1 then 2 then 3 then back to 1 then 2, etc until I released the trigger
Hold Button = 1,2,3,4,5,6repeat
-
- Xpadder Xpert
- Posts: 312
- Joined: 27 Aug 2009, 15:44
- Contact:
Re: Hold Button = 1,2,3,4,5,6repeat
Okay... I managed to pull this off... HOWEVER, it's not going to do "1, 2, 3, 4, 5, 6, 1, 2...." without the final number popping up (if you stop at "1", it'll do "1", if you stop at "4" it will display "4" as the last piece of the sequence. I'm sure there are ways to "alter" this. But, here's what I did (and it was super easy):
Button (advanced) [Turbo .10S]: "1, Stop, 2, Stop, 3, Stop, 4, Stop, 5, Stop, 6, Stop"
That's all there was too it.
I should point out... it resumes where you left off, too. If I get "1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6, 1, 2, 3" and stop, and press it again, I get "4, 5, 6...".
You can likely tweak it up a lot better than this (it was a three second test, because I'm busy in reality right now).
Button (advanced) [Turbo .10S]: "1, Stop, 2, Stop, 3, Stop, 4, Stop, 5, Stop, 6, Stop"
That's all there was too it.
I should point out... it resumes where you left off, too. If I get "1, 2, 3, 4, 5, 6, 1, 2, 3, 4, 5, 6, 1, 2, 3" and stop, and press it again, I get "4, 5, 6...".
You can likely tweak it up a lot better than this (it was a three second test, because I'm busy in reality right now).